- Description
-
Details
Dead-Soft copper head gasket for Triumph big bore kits
Fits:
- Big bore kits with 1/4" center (9th) hole
- Routt or Chatland 3.000 thru 3.060" pistons and MAP "Zero Deck" STD (3.000") & 3.010" big bore pistons
- MAP's "Zero Deck" STD (3.000") & 3.010" bore pistons
Features:
- Outer holes are sized to allow for correct positioning.
- Fully annealed Dead-Soft Copper
- Made in the U.K.
NOTE:
- This gasket is designed specifically for use with Routt or Chatland 3.000 thru 3.060" big bore pistons. This will also work well with MAP's "Zero Deck" STD (3.000") & 3.010" bore pistons. For larger zero deck pistons, see MAP9071 and MAP9072
- Measure your piston outside diameter 90-degrees from the pin at the base of the skirt
- Please be aware that when using Any Zero Deck piston that the headgasket must never be closer than .010" to the bore or piston will hit causing catastrophic damage!
Additional Information
SKU MAP9070 Material Copper Country of Manufacture United Kingdom - Additional Information
-
Additional Information
SKU MAP9070 Material Copper Country of Manufacture United Kingdom - Reviews
-
Write Your Own Review
- Product Question
-
Product Questions
I have a MAP big bore kit on my 72 Triumph TR6. I need a head gasket and piston rings. The head gasket mikes out at 3.025". The bore, however, seems to be 2.988".
Because the pistons are carboned up from running too rich, I want to hone the bore and replace the rings. The cylinder itself does not have any markings except for a"1" below the right cylinder. Please advise me what rings and gasket I need.
Thanks- Stan Koroleski - Shipping Estimation
-
You can use this section to calculate shipping costs on all available methods for the item on this page, or your entire shopping cart.
-
-
-
-
Yes No
-