DI-Rect Single Phase Regulator Rectifier Zener Diode Replacement - AC to 12v DC

 Regulates and rectifies A.C. current to maintain battery/capacitor voltage. Perfect replacement for the expensive stock rectifier & Zener diode at a fraction of the cost. 

Fits:

• Norton Triumph and BSA bikes with single-phase permanent magnet alternator up to 215 watts.

Features:

• Replacement for stock Lucas Diode-Rectifier
• Rectifies and Regulates AC to 12v DC
• Single Phase
• Will work on both postive and negative ground systems
• 2 X 2 X 1/2"
• Easy to follow wiring diagram
• Made in U.S.A.

When combined with the MAP capacitor, is the absolute best combination for battery less operation.  As a two piece assembly, the capacitor if blown will not take out the entire unit.

NOTE:  For safety, it is best to use a battery for the brightest lights, especially at idle.  
             Wiring Diagram shown is for Positive (+) ground systems only. For negative ground swap the black (brown) and red wire positions

Easy installation instructions:

• Attach yellow leads to the alternator.
• The dark brown lead is positive. This lead gets connected to the blue/brown wire on the bike’s wiring harness. This blue/brown wire should go to the battery.
• The red (or orange) wire is grounded.
• Disconnect and remove the old Zener diode on the bike. Be sure to tape up the lead so it can’t short out anywhere.
• We recommend you save the original parts.